GermanLook Forums
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

GermanLook Forums (https://www.germanlook.net/forums/index.php)
-   Transmissions (https://www.germanlook.net/forums/forumdisplay.php?f=13)
-   -   915 gearbox (https://www.germanlook.net/forums/showthread.php?t=6695)

DORIGTT February 17th 2006 11:51
So you are saying that the clutch setup from a T-2 is being used without problems?

Are the splines on the 915 mainshaft the same as the 228mm VW T-2 clutch setup?

I've tried to translate your website to get information, but it is somewhat difficult to understand.

Wally February 23rd 2006 03:43
Quote:
Originally Posted by Bugat5speed
What concerns the problems with clutch, clutch cable, hydraulic clutch and others I can tell you that we are working with a pushed clutch type. By this you can use the flywheel of the T3 bus (228 mm) and also you can use the clutch bearing. The pedal can easily be pressed and the clutch is working fine. We offer some parts for this conversion like a guidance bushing for the bus bearing. Itīs much cheaper working with this type of clutch with a 915 and itīs working very fine. We do also use this set for the Subaru Turbo conversions with 915.
Wow! That is very good news Martin!
When do you expect that all the 228mm T3 parts -> 915 will be ready to order?
Quote:
Wally, I hope I did not again make too many mistakes whilst translating. Tried to get hold of some info of the Apfelbeck-project, but noone wanted to answer me.
:laugh: Your english is just fine, at times even better than some native english spoken persons ;)
I know you have had some answers by now. They were send before, but I understood we made a mistake in the e-mail adress, as we foud-out later :o
Sorry for the confusion.

Best regards,
Walter


All times are GMT -4. The time now is 21:35.
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Đ www.GermanLook.net 2002-2017. All Rights Reserved