What rear brakes can I use on early (steel) 944 A-arms?
 

As above really? Will the later stuff fit? I want to run vented discs on the back and twin-pot 964 C2 calipers. Will the late 944 hubs work? Will I have to use the 944 driveshafts too?

Thanks guys!

Hi

I did what you want to do on my sons 1303. The pads are tad wide for 944 rotor surface.

Late 944 hubs are a different animal.

You can use your stock drive shafts if you fit a Beetle stub axle in.

Steve

http://i1184.photobucket.com/albums/...1.jpg~original

http://i1184.photobucket.com/albums/...0.jpg~original

As Steve said. You can use 86 944T rear rotor to match the caliper (24mm wide, 3mm spacers required under caliper to center rotor), or Boxster S (2000-2004) caliper (comes cross drilled, no spacing required).

Lanner

Thanks guys! So I just use all the gear straight off the 86 944T? Sounds too easy :)

Ha..its NEVER easy.... but thats part of the fun...

i spent an age tying to get my mota out last night it just wouldnt come out....then after a chat with a mate he says "you did undo the clutch arm on the 915 box didnt you" er no i didnt what a wally did that and the mota fell out...DOH

True. If it was easy it would be finished by now!!