20 miles north of Chattanooga...
|
Quote:
|
Quote:
Lanner |
Well, since Lanner gave you the measurement... I don't have to jack up my car and remove a wheel to measure.(thanks Lanner :) )
|
Quote:
http://i91.photobucket.com/albums/k2...3.jpg~original so the bore is fine until it hits at that point, i guess. |
maybe you could just mill the centering ring down a bit? My 993 cup II fit like a glove!, maybe the later car had a shorter centering ring. :confused:
BTW, a set of cheap dial calipers can't cost more than $10 at harbor freight, that way you can tell the machine shop exactly what you need milled off. Besides, they are so handy! |
yeah, i don't have a harbor freight anywhere near me, but i'm going to try to pick up some when i get a free moment.
it appears that if i machine down the wheel center then the hub will stick through, but if i machine down the hub will have have an exposed bearing? |
All times are GMT -4. The time now is 21:19. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved