Yard sale 2275 is done
Well I just got back from Jake's and this time I brought it home. It even came home in a bug. I pulled the right seat out and put it in the floor :rolleyes: .
I didn't get to take it to 6000rpm due to the rev limiter kicking in at 5800. But it made 147hp and climbing at 5500 rpm. The cool part is that the torque is huge (for a Type 1) 152 lb.ft. at 4000 rpm peak and ranges from 121 at 2000 to 140.2 at 5500. I used a prototype Type 1 DTM shroud and it did a great job. Even with Street Eliminator heads it ran coooooooooool. The break-in was a 25hp load at 2500 rpm for 30 min and the #3 cyl was rock solid at 230 deg. We had to run it at a 71 hp load 4000 rpm for a good while to get it to hit 350 deg. When this shroud is read for the market-place it will be SWEEEEEEEEET. I will post the Dyno-graph when Jake emails it to me. All I have now is the paper copy. |
SWEET! ! ! Thats awesome man... Please oh please take me for a ride in it...
|
Rockin' dude. You gonna install it on the stock tranny for now, and do the 901 switch later?
|
Yep, the 901 will have to wait. The 2275 is going in on June 5th. At Kevin Smiths house. He is having a cookout for our local club and it was planned as a tech-day to do the engine swap.
Engine swap first then cook out. |
Oh yea, Zens engine was right beside mine as I was getting mine dressed for the dyno. Looks like it is ready to install his DTM and dress for the dyno.
|
1 Attachment(s)
here's a pic.
|
cool Dave :)
what type of cam are you running? |
A Web Cam 122/125 on a small base circle. Not sure if Jake ordered any other changes to it when he called it in. But it has a torque curve like a Type 4. I will post the dyno graph when Jake emails it to me.
|
1 Attachment(s)
I scanned the dyno-graph.
|
That's cool. Do you think your transmission will hold that much power? Just wondering. :confused:
Cool pictures :agree: Mike |
No. But I'm going to a 901 this winter. I will just have to take it easy till then.
|
Quote:
you serious about that clark? yea right. that chart looks like too much fun to take it easy. |
Sweet looking power curves... Should haul some serious a$$...
|
Well it is in and runnig. Both Volvo oil cooler are blown out, just could not take the oil pressure from a fresh engine and cold oil. They blew back to back. I think they were week and would have gone sooner or later. Better to got while I had someone watching. But with just the remote filter (K&N) it did fine. Got the carbs sync'ed and the idle set. I will have to go back to Kevin's tomorrow and put the deck lid on and remove the oil cooler plumbing and bring her home (the long way). I will be swapping the engine/trans. in my son's bug tomorow for his birthday.
|
Dave,
That is great that you got it running. Pity about the oil coolers, what are you going to replace them with? |
All times are GMT -4. The time now is 01:35. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved