stubborn tubes
any tricks for getting sticky push rod tubes to break free? i am trying to get the heads off of this GA engine and just can't get them to break free.
|
Zen,
What I did was to twist them in their bores atleast a couple of revolutions, and then twist and pull... they should pop right out... I suggest wearing gloves... I've got the scraped fingers and bandaids to prove it ! Sandeep |
yea, that wasn't working for me. one of the guys on STF suggested using channel locks and a rag and that worked. i was afraid of bending the tubes, so didn't at first. But it worked like a charm. 2 minutes later, they were all out.
|
All times are GMT -4. The time now is 04:07. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved