oil pump dimensions
I have an oil pump that was supplied to me as a 29mm pump. The inlet hole does not match up to the case 100%, so I will be moving it. I would just like to know if there is someone out there who has an oil pump lying around that may be able to help me with a simple dimension.
I need the distance from the mounting flange to the end of the pump gear boss and from the flange to the end of the pump gear tooth. By mounting flange, I mean the part which the case bolts fit through, where it meets the case not where the pump cover goes on. I basically need to face cut the flange 1.5mm but need to ensure that the cam insert still fits properly and does not push on the cam. Thanx a lot guys Tony Z |
Tony
I am going to move this to the correct forum. We dont do technical stuff here in the club forum. |
Sorry, thanks
|
All times are GMT -4. The time now is 17:31. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved