RHD 944 brake master cylinder?
 

Does anyone know if there is right hand drive version of the 944 brake m/c? Or if there is only one type of m/c for both LHD & RHD 944? This is because I am not sure if the 944 m/c which I can order from some US auto parts vendors will fit RHD Bug (1303). It looks like that the front tunnel section of RHD bug will block the m/c outlets.

Its a snug fit but you can run the lines between the tunnel and the M/C.
I don't think it matters on the 944, its out in the middle of the fire wall in the engine bay.

I can't answer from fact if there are LHD / RHD differences but I can't beleive there are. I have a UK purchased (so RHD) 944 Master cylinder fitted to a torsion bar front. Looking at it in position both the front near side pipe and the rear pipe come out on the left hand, tunnel side.
Hope that helps.

Here's a pic of ours

http://www.imagestation.com/picture/...2/ee1b4ed9.jpg

Thanks for all the input. It seems that there shouldn't be any problem to fit the 944 m/c on RHD bug. I think it will fit even better if using banjo fittings.

Regards
Tim