F/S - Kennedy Eng flywheel T-4 Conversion
3 Attachment(s)
Have a look at this BEAUTIFUL piece of machining:D
Kennedy Engineering flywheel was purchased for a T-4 to T-1 conversion. I'm going another route so here it is on the chopping block. The hardware and pilot bearing are included. Purchased for $ 250 new. Paypal me $ 125 plus shipping and it's yours! Thanks for shopping in my garage.:laugh: |
O.K. O.K. I know you all want this....I'll change the price to $ 125 delivered in the continental USA
|
do you still have this?
|
Yes I do still have it.
|
Just out of curisity, do I need a special pressure plate to go with it?
|
No. It is from Kennedy Engineering for the T-4 to T-1 gearbox conversion.
|
Sweet, alright, I just bought an engine... so give me a week or two to get the money and I would love to take it off your hands.
ERIK |
I bought a type 4 2.0L for my 65 notch.... Will I need one of these to complete the conversion??? I am just getting started... any help would be good. Joel
|
flywheel
Do you still have the Kenendy flywheel? Eric.
|
Yup. It's still hanging around
|
flywheel
Thanks for the quick reply. How much? I would pick up since I am local. Eric.
|
I apologize folks.
I just checked my invoice from Kennedy Engineering and the flywheel is for a T4 - Porsche 915! ooops! |
I'll take it, pm me your # so we can set up payment.
Thanks |
Just to make sure we're clear Richard. It's a Kennedy flywheel for using a Porsche 915 transmission with a Type 4 engine.
|
If Richard does not take it, I will.
Sandeep |
All times are GMT -4. The time now is 01:49. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved