Type IV Rocker Arms
Hello everyone, with exception to Mr. Pauter, is there anyone else making type IV ration rocker arms?
|
Quote:
|
Thanks Walter.
|
|
1 Attachment(s)
Hello everyone,
Well it's good to see someone makes them. Question, have you seen the Pete Fusa rockers? I'm am not sure that they are for type IV heads though, I will send a e-mail and hope the answer is yes. |
Quote:
Unfortunately, the Weiss rockers are very expensive (double what Pauters used to cost iirc, about 850-895 euro's?) and you need their billet valve cover since their rockers sit very high. Another 300-350? I think you might be well over 1200 euro's for just rockers and valve covers... I think Apfelbeck parts might not be that expensive after all LOL! :lmao: |
Good morning,
The rockers I showed were 1.7 ratio. I believe that they are not type IV also. I emailed him because, if a company can make that quality of a part, hearing his yes or no on possibly endeavoring to make some is worth at least asking the question. 1200 euros is high. |
Type IV rockers relpy
1 Attachment(s)
Hello everyone, please see the reply concerning the type IV rockers.
Hi there On my website the rockers are typeV . It's not the same of pauter ok. I already produced type 4 of pauter, I can do this without any problems. I need a minimum order of 5 sets. Value per sets of $ 650.00 Total $ 3,250.00 Question, is there enough members to place an order? I sent another picture of his rocker arms for him to validate. I also sent a picture of my engine, as the type IV, to make it clear. I believe Pauter started to have problems with reliability of his product. When I see Fusa product, it reeks quality. Because Brazil speaks Portuguese I am trying to make my point clear. |
Latest Reply On Fusa TypeIV Rocker Arms
1 Attachment(s)
Hello,
Presently I don't have the funds. However, just as soon as I am able I'll get some. |
Nah, I save my funds for OHC rockers and parts ;-)
|
It's just a matter of time.
Quote:
|
I did design billet rockers once, i havent made them yet.
https://imagizer.imageshack.com/v2/1...924/K9hgBY.jpg |
All times are GMT -4. The time now is 11:25. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved