|
i thought that is how it should work. i was able to get it to drop some a few months ago, but it appears that it is not at stock height though.
i have it supported under the front of the pan, so nothing in the way there.
i have not looked at the backside of the beam for set screws. good point. i will check.
again, what threw me was when first pulling the nuts and plate, the adjuster went down (it was already only a few mm from the bottom) with some force and seems to be held down with some load. so i am hesitant to unscrew the adjuster for fear that it is under load. can't seem to get anything else to budge.
i am thinking of pulling the spindles carefully to see if i can get some rotation from the trailing arms.
|