Thanks Charles, it has quite some of your parts in it
Shame most of them you can't see.
@Sam: yes, your right, these plastic stacks are a bit high (75mm), but the only ones I could get my hands on for a reasonable price. You see, the bolt pattern of the filterbase of the throttle bodys is DCOE...
The filters are 100mm high.
Because the stacks are the wrong base diameter also (45mm while the th.body bore is 48mm) and cannot be widenend because of the thin wall of the stacks, we have now shortenend them to about 50mm height since the top opening is 51mm. The stacks get wider upwards. At this height the bse is now 48mm and a new thicker base plate will then be glued into place. Its an industrial 2-component glue, so I'am not that worried (yet).
Thanks for your input!
Right now I'am puzzling with the wiring diagram for the EFI set-up (i.e. connecting/installing a relais for fuel pump and general power to the ECU is already challencing for me
)
Hopefully dyno time next month
Greetings,
Walter