[Racelook]

An metal plate from 0,8mm or 1mm thick..
And an welder

Just remove your handles. Weld the holes close. Cut out the fingerhole at the back of your handles (don't know the english word for it).

Then make an plate on the good measurements and bend them on the exact same form as the door. Than weld that plates in.

P.s. you need also door- or trunkreleasers.. to open your doors after that.

P.s. Here in Holland it's legal.. but I don't know for egypt.

p.s. I also have shaved my handles on my door, but because I'm at an full resto i don't have maked the door working yet

p.s. And get info by an tuningshop or audioshop that does this stuff.. they can help you with information

Lot's of suc6

Wiebrand