Quote:
|
Originally Posted by randyj
What paint setup did you use, paint gun, compressor, hvlp?
|
Will have to check out brand, but was just an entry level high efficiency (thats what the box says!) gravity feed gun similar to HVLP but not exactly the same. 15cfm single cylinder compressor (not sure of tank size), with normal regulator close to tank plus additional filter and water trap/regulator after about 5m of hose (screwed to wall). Spies Hecker products used throughout from etch primer to high build as well as base and clear coat.
If you like I can look at the gun brand (I was told it was the level a spray paint apprentice would use [around AU$250]) - did the job well for me and certainly resulted in a lot less loss of paint through overspray than my first gravity feed gun (which required more air pressure).
hope this helps?
