|
Hi,
unfortunelatly I have not got my car running yet, (Distractions!!!! Type 2 single cab!!).
I have installed a Suzuki Barina master cylinder as it fitted my aps best, but looking at it, it would not fit in the standard hole, without a lot of mods.
The bore size works out to be about 20mm (It's imperial!) and I will be going from there, as I may get it re: sleeved larger or smaller after I have tested it.
Hope this helps
s1fter
__________________
s1fter
"Should make a good project and say goodbye to your bank balance"
www.themetricnut.co.nz
|