|
Tacked up suspension went in. Turned out it was about 8mm too long front to back, so it has to be shortened. Also, the upper back A-arm pivot was moved forwad 30mm. In the original position, quite I bit of body would have to be removed from the inner fender well. At 30mm forward, the arm should clear the body. There will still have to be a small notch removed from the inner fender well for the tie rod, but it should be much smaller than wheat was needed for the arm clearance. The center section of the suspension JUST goes in with mm to spare, but it fits and bolts up great.
Jason
|