Quote:
|
Originally Posted by Panelfantastic
Educate me a little... bias bar means you have independent cylinder and resevoir for the front and rear and the bar limits pressure on one or the other?
Jeff-
|
Yeah, there's a bar that runs between the front and rear master cylinders. On the bar is the sliding linkage. You can get a remote adjuster that is a knob that when twisted, will pull or push the linkage along the bar. It adjusts the pressure that each master cylinder sees.
Hopefully, if I select the right master cylinders, I won't need to get the proportioning valve, and just the balance bar will be enough to dial it in.
"you can buy a good flaring/bending tool for less than $100 from most places"
I've got a couple of benders already, but I don't have a flaring tool. I've also heard there are specific flares for specific situation ie the angles, so I'm going to have to do a little research before I can get it done.
Jason