|
thanks for the reply guys,
the clearance issus is wheel to spring plate on a 1303, one side is 5mm closer than the other, this could be due to tracking adjustment not being set yet.
that deals with the why,
so running with different spacers is ok.,
i will proceed to make some 6mm spacers, out of plate and pull the washers out that i have been using.
as for hubcentric, they aint, co sthey are on the rear with CB perf rear disc setup, there is no lip to locate a spacer or wheel off for that matter, very similar to the stock arrangment where the bolts pull the wheel in centerally.
|