[speedy]

Mike, there is no easy answer , i tackled the beam and added camber buy extending the bottom tube but this is difficult .Many people have said to bend the top arms in with a hydralic press 10mm will correct it but it is weather you can find anybody to perform this .
I have read that people have heated the top arms to bend them and have had no problems but i personnally wouldn't heat them .
If i was to do it again i think i would have the bottom beam rubber bushes made out of ptfe( hard self lubricating plastic )that is often used in bushings and extended 10mm further out , a cheap fix as they are not difficut to make in a machine shop and cut down an old set of springs and redimple them 10mm further out .
I must stress i have not done this but would if i needed to change the camber again rather than tackle the beam.
hope this helps
jon