|
Turbo
I am just stating to collect some bits tohgether for an eventual turbo conversion and was wanting some advice for a type 4 2.0
I already have a T3 charger spec below
Features a 3" Inlet and 2" Outlet
Features Wet Float Bearings
1/8 NPT Oil Inlet
.50 A/R Compressor
.63 A/R Turbine
T3 Flant
5 Bolt Standard (.58) Down Pipe Flange
Turbine Wheel: Exducer: 2.2", Inducer: 2.58"
Compressor Wheel: Exducer: 3", Inducer: 2"
I was wondering what sort of single carb would be good to use with this )using porche shroud on the engine, also what inlet manifold and exhaust manifiold... are they all custom made? who make them etc
Any advice would be great
Cheers Jim
|