Thanks Humble, I appreciate it! I would go with the forged, but can't afford them right now and probably wont need them because I'm not going to push this car too hard a whole lot. Just some toying here and there, but mainly cruising and taking it to shows. It'll see the track a couple of times too.
Well, some good news. I ordered an Eagle Specialty Products internal balance stroker crankshaft for my 350.
http://store.summitracing.com/partde...P-10350375057I
And I bought some (383) Speed Pro dish pistons.
http://store.summitracing.com/partde...t=STL-H859CP30
Both parts will work well with my stock 5.7" rods. So I'll save some $$$ there. Coolest part is I did some shopping around and found the crank for $231 here...
https://www.horsepowerparts.com/inde...oduct_id=21684
and a set of 8 pistons here...
http://www.kmjent.com/cart/product.p...9&bestseller=Y
...I called summit up and said, "I'd like to buy these parts (I listed stock #s and he gave me the pricing) but I found them cheaper here (I then gave him the website URLs)". They beat their competitors prices by $1 for each product. Summit has a beat-a-price guarantee so I thought I'd see if it was baloney. It wasn't. I got the parts for $407 with shipping. At Summit's pricing it would've been $522 total with shipping. So I saved over $100 smackers.
So I have all my parts, or they're being shipped, and the motor can go together soon. That is after hot tanking, decking, and balancing. I might not have the assembly balanced if the bob weight of my pistons, pins, rings, bearings, cap screws and rods are fairly close to the neutral bob weight of 1825 +/- 2% from Eagle. Maybe balancing will be cheap enough if I give the machine shop the bob weight and they only have to balance the crank? We'll see...