Zen,
Yup, those are the ones. I just drilled the bail area so they just push in. I used loctite to secure them into the aluminum peice that the fan mount bolts to.
As for the breather, I bought the Bugpack breather kit and it came with the fittings that have an o-ring.
I drilled a hole BEHIND the breather tower (instead of the side, like in the instructions) because I'm going to route the breather tube THROUGH the shroud to keep the engine bay as clean of hoses as I can.
As for the oil filling, I filled the case before I bolted on the fan mount. On my engine, I have a factory breather vent on the right head (when viewed from the rear) where one of my breather tubes fit. Its really easy for me to fill the case from this fitting.
BTW, I talked to Oliver about the factory oil filter location. He said I could use the factory location with the BAS but use a smaller dia Rabbit filter. I'm getting the header ceramic coated anyways so this should help keep the radiated temps down in that area.
Hows your install coming ? I hope to have mine done in the next 3 weeks. I'm STILL waiting for my fan assembly to get here ... #@$$# USPS !
Sandeep
|