Thread
:
'56 rag with a twist
View Single Post
#
260
August 17th 2013, 11:31
fahrvergnugen
Registered User
Join Date: Jun 2009
Location: The Netherlands
Posts: 285
Started on the cage today. With these holes I can lower the cage a bid and weld the up side.
Bending the bends in the wright position and keeping it straight is a PITA.
Did you see my special cupper angle measure tool ;D
Paul.
__________________
If some is good and more is better, then too much should be just about right!
fahrvergnugen
View Public Profile
Visit fahrvergnugen's homepage!
Find all posts by fahrvergnugen