View Single Post
  #22  
Old March 15th 2016, 21:00
Jadewombat's Avatar
Jadewombat Jadewombat is offline
Registered User
 
Join Date: Jun 2010
Location: Houston, TX
Posts: 159
Turning the center caps is a lot of time, but pretty fun and I'm learning quite a bit about machining. It's 3" aluminum round rod and the rims are of course metric, but easy enough to work with. I need to hollow out the area facing the tailstock here, then test fit on the rim hub before turning it down to a pointy section.

__________________
'66 Bus(11-window, CLK rims, disk brakes, IRS, bags, hydr. clutch, Super-1600 w/injection)
Reply With Quote