Quote:
Originally Posted by jc_geddes
I have just made the 2 5mm spacers and inserted them behind the bearing seats. Whne tightened up there is still play, as if the bearings are loose. It appears that the spacers need to be a bit bigger then 5mm, I am going to check today, so will beable to report back.
|
You are right John.I made them 0,5mm higher en the problem was gone!!
I masured it up and the Hub had to go 11mm up.
Then you can make a bracet for the brakes of 6mm. and bold it on to your spindle!!
Quote:
Originally Posted by Fred100
but which material usinf for space the bearing ??? aluminium?
|
I used Iron because of the size of the spacers, There not that big. My meaning was that Aluminuim is too weak for those sizes!!