[biofatty]

I have all these nice parts out of what i was told was an 87 944NA. I had some suggestions to replace the majority of the rear parts of this to go into my 64 type 2 double cab. I was also told to only keep the caliper and carrier in the front and get early 944NA hubs.

I was told to use the 83-85 944NA parts instead but was wodering if anyone has used these parts below in an IRS install or has any suggestions on installing any of the parts in my bus. I am not opposed to cutting or welding, so dont be shy.. I have all this stuff and would like to use it but if i have to roll back the the early 944 parts I will if it is the best bet. I realize the 944 front parts i have cannot be used without machining as well.