Thread: '56 rag with a twist
View Single Post
  #260  
Old August 17th 2013, 11:31
fahrvergnugen fahrvergnugen is offline
Registered User
  
Join Date: Jun 2009
Location: The Netherlands
Posts: 285
Started on the cage today. With these holes I can lower the cage a bid and weld the up side.


Bending the bends in the wright position and keeping it straight is a PITA.


Did you see my special cupper angle measure tool ;D

Paul.
__________________
If some is good and more is better, then too much should be just about right!
Reply With Quote