Quote:
Originally Posted by GeorgeL
Hmmm, just a wild guess, but couldn't a muffler shop do that sort of bend?
George
|
Good question. That was originaly one of my options, But I'd have to have the pan at the muffler shop to get the right angles. If I didn't and it was bent wrong, because I didn't figure the angles right, I'd be stuck. Welding might not have been the best choice. But I thought it was good to work with the tools and skills I have. Still, with 1-1/4" ID tubing, I doubt I'll have a flow problem. If anything it'll be too big.
__________________
Mike
'04 R32 Tornado Red
'02 New Beetle TDI - Daily driver
'64 Ghia - Project!!-Subaru EJ20T, MS/EDIS, 993 brakes, 914 Tranny...
Last edited by Mikey; April 8th 2006 at 01:28.
|