View Single Post
  #45  
Old August 1st 2018, 21:15
Jadewombat's Avatar
Jadewombat Jadewombat is offline
Registered User
 
Join Date: Jun 2010
Location: Houston, TX
Posts: 159
Got some welding done this week on a bar for the rear seatbelts before I clean up the last of the firewall inside and the floor. Powder coated it today and did a test fit. I ran out of CO2 gas a while ago and have been using flux core wire. Doesn't look quite as pretty, but not bad. Took me a while to put speed holes in the bracket with my bench punch, but of course would've taken considerably longer drilling the holes.

You can see the paws of my helper there up on the shelf, .
Attached Images
File Type: jpg SeatbeltBracket2.jpg (80.1 KB, 9 views)
File Type: jpg SeatbeltBracket.jpg (79.8 KB, 6 views)
__________________
'66 Bus(11-window, CLK rims, disk brakes, IRS, bags, hydr. clutch, Super-1600 w/injection)
Reply With Quote