You need the rear backing plates from a 924S. They are steel and basically replace the drum backing plate. You re-use the bearing retainer from the VW setup. It is recommened that you drill a hole in the 924S backingplate to give the oil a place to drain (like the drum backingplate has). Then you can use either 924S or early (83-85) 944 rear hubs. If you have short axle, chop 16mm off the front of the Porsche hub. Use all the early 944/924S ebrake parts and add rotor/caliper and you're done!
Or, talk to MBT. They make the backingplate specifically for swingaxle cars.
Lanner
|