View Single Post
  #31  
Old January 12th 2011, 11:22
al_kaholik al_kaholik is offline
Registered User
 
Join Date: May 2007
Location: London/Lincolnshire
Posts: 225
Gents, we need to pool some info.

Also how thick do our adapter plates need realistically to be? And how are we sealing to the bell housing face - can we go as far as clearancing this a bit and using a different seal or indeed the rear of the slave cylinder.

Ive been chatting to a guy at Sachs about one.

Its a VAG 1.9TDi part that will require some mods, but it is

~40mm pressed total height, ~33mm to the mounting face
~60mm extended total, ~53mm to mounting face
single pipe to feed/bleed
60mm OD bearing face
PCD of mountings ~85mm

I have some nice spec/pictures too which is very useful.

Luis, is it possible to get those sort of specs from yours?
Reply With Quote