View Single Post
  #5  
Old June 29th 2017, 12:02
Wally's Avatar
Wally Wally is offline
Registered User
 
Join Date: Nov 2002
Location: The Netherlands
Posts: 2,542
After half a year of chasing parts and finally test fitting them and even driving a few meters with it, it turns out the volume needed to push 6 pods back in is too much for my (already uprated to 23,8mm) master cylinder...

It seems 996 GT2/3 uses 25,4mm master cylinder diameter. It hard to grasp why 23,8mm is then really too small.. Pedal dives all the way in after you release the brake and brake again. After two, three stumps its back up and very hard/solid, but that just won't do of course.

That was/is extremely frustrating to find out after so long. I am not ready for Tilton clutches and all, so if other good ideas fail, I will (need to) go back to a smaller disk and caliper and be done with it.
__________________
'75 Super.
...because race car!
Reply With Quote