View Single Post
  #3  
Old April 9th 2015, 10:31
Fiatdude Fiatdude is offline
Registered User
 
Join Date: Feb 2015
Posts: 119
Here is the engine that I had decided that I wanted to put into it..... Notice anything strange



This engine was originally purchased and built in 1987. It is based off a ARPM case and barrels, and has angle port heads. It's displacement is 2989cc's, almost 3 liters. It uses Siamese cylinders to that 4" SBC chevy pistons and rods can be used -- and with a 90mm crank, offset ground to accept the small journal chevy rods. -- -- It also incorporates a drop cam placement of 150 thousandths so that there is no cam interference with the big crank..... ARPM also used a very different head stud setup with 6 main 1/2" studs and 4 smaller studs.... All this means is that if anything breaks, I will be so screwed to replace it LOL





This engine is also 3" wider than stock, so there is a lot of modifications required to get it to fit in any VW

Last edited by Fiatdude; April 9th 2015 at 11:14.
Reply With Quote