View Single Post
  #1545  
Old January 21st 2020, 15:38
Wally's Avatar
Wally Wally is offline
Registered User
 
Join Date: Nov 2002
Location: The Netherlands
Posts: 2,552
Somehow its been too long since an update! And this great forum can use a little more traffic I think.

The 102mm Deutz cylinders have been machined, new JE pistons with dish have arrived also and new JPM cam is awaiting as well.

I had damaged a Pauter valve adjuster, but Pauter wasn't too keen on sending me a replacement, so I looked online (JEGS) for the 3/8-24 adjuster with solid cup. Crower is the one Pauter used as these was exactly the same
Very relieved I found it and it turned out to be the same one!

The new Nascar Ti valves I bought had a very unusual valve angle, so a new cutter (55 degrees) had to be ordered. We still wait till my shop gets it, so the heads can finally be finished as well.



Reply With Quote