View Single Post
  #23  
Old March 18th 2016, 21:49
Jadewombat's Avatar
Jadewombat Jadewombat is offline
Registered User
 
Join Date: Jun 2010
Location: Houston, TX
Posts: 159
Hollowing out the inside of the cap takes a long time. I'm using a 2 1/8" (54mm) forstener bit which I know wasn't made for cutting aluminum, but I don't really care. It works and would take almost infinitely longer if I tried to just hog out the center with the carbide cutter.

Pulled the cap off and checked it for fit on the rim. Looking good and the dog approves. Just have to remove a little more to clear the axle nut, then open up the inside bore 1mm to clear the front rotor dust caps.


__________________
'66 Bus(11-window, CLK rims, disk brakes, IRS, bags, hydr. clutch, Super-1600 w/injection)
Reply With Quote