View Single Post
  #7  
Old January 7th 2007, 00:14
Veedub Veedub is offline
Registered User
 
Join Date: Jan 2007
Posts: 269
Quote:
Originally Posted by ccain529 View Post
OK, so I'm new here and I apologize if this is duplicated info!
I've been doing a lot of research and found this in the February 2005 HotVw's.
The info comes from Jon Chabot from TopLine
I tried to scan it, but it didn't take, so I recreated it! I hope this helps!
Like I said before, I'm sorry if this is repetitive!
According to the article in the magazine, This is a chart for fitting 17's under stock fenders of a 1302 or 1303. The article says that the 17's will fit under the fender with no problems. The problems occur when you try to lower the car and stick those super positive offset wheels under the fender. The article was written assuming you use 17X7's with the rubber listed on the chart. The article also cautions that your wheel spacers should be correctly machined.
does the same go for the rear of a 72 standard bug, with a 40mm-50mm offset?front i assume id have to narrow.Also would same rules go for a 15x7 or 15x6.5 in rear?
Reply With Quote