View Single Post
  #28  
Old August 30th 2020, 22:46
Hoghead Hoghead is offline
Registered User
 
Join Date: Oct 2006
Posts: 111
My Imohr "Top" front suspension that used fabricated, dropped spindles, just arrived this week. The welds while not bad looking are not beautiful stacked dimes.

I did not ask about a front sway bar, and at this point do not even know if one is needed.
JMD - is that a sway bar mount on the front of your forward plate and bushing in the top a-arm?

The 350lb front springs seem a bit stiff, even with the 3 lower mounts to vary the lever ratio??
Already changed to QA1 shocks and now thinking about spring rates and asked in a post about corner weights
https://www.germanlook.net/forums/sh...ad.php?t=11998

I now need to make some front hubs as foolishly did not order from Imohr with the IFS. Wheels and brakes are 996
Anyone have a hub drawing?

Last edited by Hoghead; August 30th 2020 at 22:54.
Reply With Quote