View Single Post
  #14  
Old May 16th 2006, 20:37
speedy's Avatar
speedy speedy is offline
Registered User
 
Join Date: Jun 2005
Location: darlington england
Posts: 202
well i had the bottom leaves out today and measured everything up ,the dimples were an equel distance from the ends of the leaves ,the beam adjuster was off center ,all the arms were a snug fit in the bushes possibly 1 mm movement ,measured the top and bottom torsion tubes and found the problem when the tubes have been welded on or narrowed in the past the top tube has been welded offset to the LHS by about 4mm, so pulling one side in at the top and the other side out at the top , this is i suspect an aftermarket mexican-brazilian beam ,utter s***
i am going to take the beam off tommorow and take it to work with me ,remove the top bushes and remove the offending 4mm on the LHS replace the bushes and redimple the torsion leaves hopefully this will give me 0-to -0.5 -ve camber on both sides , time will tell
__________________
woop woop
67 2276 turbo
64 ghia 1776
zx7rr
Reply With Quote