[dub_crazee]

thanks again everyone - you're comments have spurred me on to get it done! mx67 bearing adapters were made to run beetle bearings on the spindle. a few mm was taken off the back of the hub, and a small area of the back of the spindle was spotfaced to create a flat face to mount the caliper bracket. then a hole was just drilled and tapped to bolt the bracket on it sounds simple but did cause a couple of headaches regarding the best place to put the caliper ad best way to mount it.

got my car back from Pete today and he's done a great job. It's REALLY hard to photograph the black headliner on a bright day against a birght colour so the pictures dont really do it justice!













il get the windows in next week