1. front tins only
2. my nutserts had holes drilled. i'd drill em before installing. #30 = .1285". mark where the nutsert nut should go and drill it for a slip fit with the nut. then put the nutsert in the hole upside down to mark the rivet hole locations as pre-drilled.
4. Used a "universal" cable. Cut to length. Cut accel. tube about 1.5".
5. both mufflers are below the sump -- about 1". the cross tubes are at about the same level. the header is tucked up flush to the sump. my left might droop a little without the left muffler bracket to the tailpipe. theres plenty of room for filter adapter and lines with the left muffler on.