Hello !
I ran 52et offsets on the front with 15/20mm spacer from performance technologies and 23 offsets in the rear with the same spacers. No fitment problems at all.
I'm going to try to run 944t brakes this summer so my track my increase slightly again and I
may be able to get rid of the spacers.
Good Luck !!
Dan
Quote:
|
Originally Posted by Dasdubber
Hi Dan - that is a great ride you have there...muchos credit to you!
How did you go fitting the wheels on the rear (Swing axle right?) - many clearance probs? Any spacers required?
I am using a 68 s/a pan with CB discs all round (short axles), stock width BJ beam and a 63 body. I have just bought a set of 17x7.5in replica Cup3 turbo twists (all ET52). The fronts seem to fit okay (although body is still off pan) but the rears hit the spring plates and bump stop...I'll have to run spacers, just trying to figure out how wide they'll have to be!
Any help is appreciated.
Alan
|