I used a 8x8 inch panel and bent it a 15 deg. down the center, then took the upper/aft. corner off. Lay it in the fender well and trace it out. Lay out your cut lines 3/4 inch inside the tracing and cut it out on the inner line. Drill the fastener holes tru both the panels and the fender wall and mount the nutplates.:agree:
__________________
NO_H2O
72 1302 Smack Black GL
73 Bus (2L CIS Powered)
66 Beetle, 73 Standard Beetle
72 Pinzgauer 710M
Volksport Kafer Gruppe
|