[Sandeep]

I have mounted the 930 rear rotor to the 944 ebrake assembly !

At first attempt the rotor bottomed out on the backing plate (I had to find 13mm more clearance)...so I added another spacer (the steel spacer that slides over the axle from the splined side, it just happens to be 13mm thick !) and it sits fine now....the 944 ebrake engages in the proper area on the 930 rotor....

The axle nut also JUST fits...you can tighten it up and still JUST BARELY get the cotter pin in...this increases the track per side by another 13mm....good for my application because I needed a 10mm spacer to get the 18x10 wheel off of the spring plate...so Killed 2 birds with one stone !

Now, all thats left is to get the 944T front calipers to mount on the rear, and figure out the ebrake cable setup.

Sandeep