#1
|
||||
|
||||
1303 floor pan dimension ?
Wasn't sure where to post this question but...
Does anyone have a bare 1303 floor pan, I need a measurement from the rear of the torsion tube to the end of the frame horns. Any help would be much appreciated.
__________________
gee dub |
#2
|
||||
|
||||
Nah, no loose floor pan but my engine is out, so then measurement would be easy then too right?
Rear of torsion tube is against the tube vertically? Last edited by Wally; January 21st 2016 at 15:36. |
#3
|
||||
|
||||
don't forget it necks in for the splined section..
__________________
http://www.ricola.co.uk |
#4
|
||||
|
||||
Thanks fellas, I ve sent you both pm's .
__________________
gee dub |
#5
|
||||
|
||||
i have a bare 1303 pan that i can get measurent for ya.
|
#6
|
||||
|
||||
Ah thanks CookVW that would be great. As Ricola has said the torsion tube necks in for the splined section so if you could please give the dimension from the main/large section of the torsion tube that would really be helpful.
Graham
__________________
gee dub |
#7
|
|||
|
|||
#8
|
||||
|
||||
Quote:
__________________
gee dub |
#9
|
||||
|
||||
i will get you the needed dimensions in the morning and ill post them up asap.
|
#10
|
||||
|
||||
Hi Just measures a spare 75 1303 pan at the side of my garage, its 53cm, thats from a straight edge across the ends of the horns to the torsion bar tube just out from the pivot box
__________________
STI powered 1303 in the works. |
#11
|
||||
|
||||
Thanks for taking the time to do that Steve
__________________
gee dub |
#12
|
||||
|
||||
Quote:
Thats what I like about this site/forum, you post a question, it gets a handful of views and within a week people are jumping in and helping out .
__________________
gee dub |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|