|
|
#9
October 24th 2007, 00:27
|
||||
|
||||
|
I'm having 034 build a harness for me, I think it actually uses the stock H2O temp sensor so that is taken care of, and then I can just set what temp I want it to come on at.
Pulled the motor and tranny out for the last time. Wanted to make sure everything inside the clutch was buttoned up OK, found that I had forgotten to tighten the bolts on the driver side CV!!! Double checking is a good idea apparently.... Welded up the gaping holes where I cut the frame horns off at the torsion tube. Engine back in then wait till new harness and throttle cable arrive from 034... Jason
__________________
If I could just get paid for my sleepless nights.... 1960 VW Bug UBRDUB Walkaround 1st Drag Run Dyno Run Oval Ragster-'57 Rag/'04 Boxster S 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode