GermanLook Forums  

Go Back   GermanLook Forums > Technical Section > Electrical

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #6  
Old May 22nd 2006, 06:24
Mikey's Avatar
Mikey Mikey is offline
Registered User
 
Join Date: Aug 2004
Location: Owensboro, Kentucky, USA
Posts: 637
Check out my setup. It's a Ghia, but I'm using autometer guages. I was originaly going to go Type 4, so I bought my guages tailered to an aircooled engine. (oil temp, oil press, and CHT.) but left to right

CHT, Tach, Fuel Level, Speedo, (top 2) Boost/Vac, Water Temp, (bottom 2) Oil press, oil temp.

I wasn't sure about using all the guages but I figured I had them, I should just use them. I still might change out the CHT. Like my racing wheel in the last picture?
Attached Images
File Type: jpg Guages 001 (Small).jpg (51.0 KB, 293 views)
File Type: jpg Guages 003 (Small).jpg (49.0 KB, 237 views)
File Type: jpg Guages 004 (Small).jpg (57.7 KB, 241 views)
__________________
Mike
'04 R32 Tornado Red
'02 New Beetle TDI - Daily driver
'64 Ghia - Project!!-Subaru EJ20T, MS/EDIS, 993 brakes, 914 Tranny...
Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 02:54.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved