|
|
#2
October 3rd 2002, 10:09
|
||||
|
||||
|
It could have been machined to deep.
I did the conversion with the specs in my artilcle on the main page. It did not hit the rotor but it was very close. You could get a spacer machined which will go on the spindle so that the bearing can not silde all the way to the back of it. Who else has a suggestion? Alex 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode