Lets talk about it.

[thomas_niji]

Hey NO_H2O

Did you need to drill a hole to run the wires? I tried to run them today, and I tried to push the new wires through where the original wires are, on the left side of the engine bay. There's a big chunk of sponge over there........ couldn't get through....... Am I doing it the way you did it....? I must say I don't quite understand how you run them....

Thank you so much....

[NO_H2O]

I went out under the back seat drillrd a hole and used a gromet to seal the hole. I used a nylon spywrap to protect the wire bundle and routed it along the side and secured it with a couple of adel clamps.