front beam urethane

[rip]

Originally Posted by flat

Rip,

When I narrow/adjust a beam, I usually throw out the stock needle bearings/micarta bearings. I like the urethane inserts (the long ones for both inners and outers). As a plus they have a built in grease seal. You gotta keep them greased well and you will not have to worry about squeeking. I like the 'empi' ones better than the 'bugpack' The bugpack are too stiff and a b**ch to put in sometimes.

Good luck.

Lanner I got the full sized top one but the bottom beam urethane comes in two pieces, (bug pack). Frankly I'm questioning going though the trouble of replacing the inners.

I may cut the top full sized ones so I just have the outer bearings. But how did you pull yours out?

thanks
Rip

BTW got the email thanks again for the help