|
|
|
|
#1
December 11th 2005, 08:24
|
||||
|
||||
|
Car is going to be dark silver.
That picture is somthing in the right direction. but i also want the mesh to be about 3cm in from the front plate if you know what i meen. i dont want the sharp edges from just cutting the plate. want to bend the edges innwards kind off.
__________________
Check out my project pic`s! http://www.v-dubs.no/haraune 
|
|
#2
December 11th 2005, 08:26
|
||||
|
||||
|
this kind of thing:
http://bb.bbboy.net/vwengineconversi...um=8&thread=45 bether pics: http://www.bugaru.com/
__________________
Check out my project pic`s! http://www.v-dubs.no/haraune
|
|
#3
December 11th 2005, 08:34
|
||||
|
||||
|
somthing like the lower intake on this:
http://www.xs4all.nl/~luukb/cobra51.jpg
__________________
Check out my project pic`s! http://www.v-dubs.no/haraune
|
|
#4
December 13th 2005, 20:44
|
|||
|
|||
|
Just what i would do...
1. cut the hole i like 2. transfer the pattern of the hole onto a cardboard (tricky part) 3. make a "tube" of the shape of the hole and weld it at the back of the front apron... I know its a lot tricky to match the curve of the apron, but i believe its worth it. also first mark the hole, then cut about an inch or less (hole smaller than the sketch) so you will be able to make some relief cuts and bend the extra metal inwards to support the "tube" or use the apron noted by kafer mike and make a "tube" Chris
__________________
Aircooled 4ever 1973 1303 going towards GL
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
