single wiper conversion

[kitchenware]

ok, perfect time to pull this thing out of my mk2...

Here's the assy with the mk3 motor.



Here is the assy flipped over and the problem that will require you to drill your center hole a touch lower than the stock positions. the arm with the arrow pointing toward it needs more room to operate...



Here the assy is sitting in the stck location with that arm in the 12oclock position (where it hits the firewall and at it's outermost position). As you can see, it's close enough that putting that hole slightly lower would remedy the situation.


Clear as mud?

Since I've got it out now, I'll drill the hole tonight or tomorrow and get it all mounted up.